色婷婷av一区二区三区麻豆|婷婷色国产偷v国产偷v|婷婷网色偷偷亚洲男人甘肃,中文字幕乱码人妻综合二区三区,无码人妻精品一区二区三区久久久 ,24小时日本免费观看视频

    

      

          



          


              

          

          

 
          

          
    
          
    
          
    Principle of formula design of friction plate

          
    
          
    
          
    Published:

          
    
          2022-11-23
          

          
    
          wangda
          


          

          
    
          The friction plate achieves various properties of the product through the ratio of various friction materials by the R&D personnel. In the ratio, the R&D personnel will use the comprehensive ratio of various materials instead of adding them in large proportion for a certain performance, which will make the friction plate produced cannot be used normally. The proportion of friction materials is required by certain requirements, and we will talk about the principles below.
          


          1. Scientific principle:
          


          (1) Meet the performance requirements of friction plate.
          


          (2) Understand the physical, chemical and structural characteristics of friction materials
          


          (3) Pay attention to the influence of coordination on product quality
          


          (4) Pay attention to the amount limit of various friction materials
          


          (5) Various collocation of low-cost friction materials
          


          (6) Use of additives
          


          (7) The typical formula can not be used mechanically
          


          2. Economic principle:
          


          (1) On the premise of meeting the service performance of the friction plate, the friction materials with lower price shall be selected as far as possible
          


          (2) Develop local friction material resources and obtain materials nearby
          


          (3) The formula is applicable to the process method with simple process, high productivity, short production cycle, less energy consumption and material consumption, and less investment
          


          3. Principle of legality:
          


          There are two kinds of product standards issued by the state, one is recommended standards, the other is mandatory standards.